Converter Housing Side
WARNING: This page is about a different variant/trim than selected.
- Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
- Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6AX-EL] .)
- Remove the transfer. (See TRANSFER REMOVAL/INSTALLATION [GW6AX-EL] .)
- Remove the oil seal using a flathead screwdriver.
- Using the SSTs and a hammer, install a new oil seal.
- Apply ATF to the lip of the oil seal.CAUTION:
- Do not touch the spline of the front drive shaft because the oil seal can be damaged easily.
- Install the transfer. (See TRANSFER REMOVAL/INSTALLATION [GW6AX-EL] .)
- Add the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6AX-EL] .)
- Install the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
- Perform the "Mechanical System Test". (See MECHANICAL SYSTEM TEST [GW6AX-EL] .)