Water Hose: Notes

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the following parts as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [VIN Y ] .)
- Air cleaner cover
- Air cleaner element
- Fresh-air duct
- Air cleaner case
- Air hose
Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [VIN Y] .)
Remove the turbocharger air outlet pipe component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [VIN Y] .)
Remove the front under cover No. 1. (See FRONT UNDER COVER No. 1 REMOVAL/INSTALLATION .)
Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [VIN Y] .)
Remove in the order indicated in the table.
Install in the reverse order of removal.
Add the engine coolant. (See ENGINE COOLANT REPLACEMENT [VIN Y] .)

Courtesy of MAZDA MOTORS CORP.

OIL COOLER COMPONENT OPERATION

Component no	Refer to
1	Water hose component (See WATER HOSE NO. 1 AND NO. 2 (OIL COOLER SIDE) INSTALLATION NOTE .) (See WATER HOSE NO. 1 (WATER PIPE SIDE) INSTALLATION NOTE .) (See WATER HOSE NO. 2 (WATER PIPE SIDE) INSTALLATION NOTE .)
2	Hose clip
3	Water hose No. 1 (See WATER HOSE NO. 1 AND NO. 2 (OIL COOLER SIDE) INSTALLATION NOTE .) (See WATER HOSE NO. 1 (WATER PIPE SIDE) INSTALLATION NOTE .)
4	Water hose No. 2 (See WATER HOSE NO. 1 AND NO. 2 (OIL COOLER SIDE) INSTALLATION NOTE .) (See WATER HOSE NO. 2 (WATER PIPE SIDE) INSTALLATION NOTE .)