Throttle body component Removal Note

WARNING: This page is about a different variant/trim than selected.

Remove the front under cover No. 1 and front under cover No. 2. (See FRONT UNDER COVER No. 1 REMOVAL/INSTALLATION .) (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT (VIN Y) .)
Drain the water-cooled charge air cooler coolant. (See WATER-COOLED CHARGE AIR COOLER COOLANT REPLACEMENT (VIN Y) .)
Disconnect the water hose No. 1 and water hose No. 2 shown in the figure.

Courtesy of MAZDA MOTORS CORP.
Remove the throttle body component.