Throttle body component Installation Note

WARNING: This page is about a different variant/trim than selected.

Remove the throttle body component.
Install the water hose No. 1 and water hose No. 2 shown in the figure.

Courtesy of MAZDA MOTORS CORP.
Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT (VIN Y) .)
Refill the water-cooled charge air cooler coolant. (See WATER-COOLED CHARGE AIR COOLER COOLANT REPLACEMENT (VIN Y) .)
Install the front under cover No. 1 and front under cover No. 2. (See FRONT UNDER COVER No. 1 REMOVAL/INSTALLATION .) (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)