Front Oil Seal Replacement (VIN Y): Notes
WARNING: This page is about a different variant/trim than selected.
Special Service Tool (SST)
| 1.: Mazda SST number 2.: Global SST number |
|
| 1: 49 UN20 5072 2: 205-072 Holder |
|
| 1: 49 B011 105 2: - Adapter |
|
| 1: 49 H010 401 2: - Oil seal installer |
Replacement Part
| Front oil seal Quantity: 1 Location of use: Engine front cover |
Oil and Chemical Type
| Engine oil Type: Recommended oil |
WARNING:
- A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing.
- Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
- Remove the front splash shield (RH). (See FRONT SPLASH SHIELD REMOVAL/INSTALLATION .)
- Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION (VIN Y) .)
- Remove the coolant reserve tank. (See COOLANT RESERVE TANK REMOVAL/INSTALLATION (VIN Y) .)
- Remove the No. 3 engine mount. (See NO. 3 ENGINE MOUNT DISASSEMBLY/ASSEMBLY (VIN Y) .)
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
Courtesy of MAZDA MOTORS CORP.
FRONT OIL SEAL REPLACEMENT COMPONENT OPERATIONSComponent no Refer to 1 Crankshaft pulley lock bolt
(See CRANKSHAFT PULLEY LOCK BOLT REMOVAL NOTE .)
(See CRANKSHAFT PULLEY LOCK BOLT INSTALLATION NOTE .)2 Crankshaft pulley 3 Front oil seal
(See FRONT OIL SEAL REMOVAL NOTE .)
(See FRONT OIL SEAL INSTALLATION NOTE .)