LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly (VIN Y) >> No. 3 Engine Mount >> Notes

No. 3 Engine Mount: Notes

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Slots have been adopted for the No. 3 engine mount installation holes. If the No. 3 engine mount is deviated from the original position when installing the No. 3 engine mount, engine noise or vibration could increase. Before removing the No. 3 engine mount, place alignment marks on the No. 3 engine mount and body so that they can be assembled to the same positions as before removal.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION (VIN Y) .)
  3. Remove the coolant reserve tank. (See COOLANT RESERVE TANK REMOVAL/INSTALLATION (VIN Y) .)
  4. Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
  5. Remove in the order indicated in the table.
  6. Install in the reverse order of removal.
    Fig 1: No. 3 Engine Mount Components Location With Torque Specification
    G16379581Courtesy of MAZDA MOTORS CORP.
    NO. 3 ENGINE MOUNT COMPONENT OPERATIONS

    Component no Refer to
    1 No. 3 engine mount bracket
    2 No. 3 engine mount
    (See NO. 3 ENGINE MOUNT REMOVAL NOTE .)
    (See NO. 3 ENGINE MOUNT INSTALLATION NOTE .)
scientia non olet · About LEMON Manuals