LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly (VIN Y) >> No. 3 Engine Mount >> No. 3 engine mount removal note

No. 3 engine mount removal note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • To prevent deformation of the oil pan, support the engine using the following methods.
    • When using an engine lifter, insert rubber of appropriate size (approx. 20 mm {0.79 in} thickness) between the engine lifter and the oil pan to support the oil pan.
    • When using a garage jack, place rubber of appropriate size (approx. 20 mm {0.79 in} thickness) on a batten which is large enough to cover and support the oil pan.
  1. Before removing the No. 3 engine mount, support the engine (oil pan) using a commercially available engine lifter or garage jack.
    G16379582Courtesy of MAZDA MOTORS CORP.
  2. Place alignment marks on the locations shown in the figure so that they can be assembled to the same positions as before removal.
    G16379583Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Paint so that the No. 3 engine mount is framed on the body side and the outline of the nut is framed on the No. 3 engine mount side.
  3. Remove the No. 3 engine mount.
scientia non olet · About LEMON Manuals