Map Light Inspection

Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the following parts:
1. A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION .)
2. Female wedge (See FEMALE WEDGE REMOVAL/INSTALLATION .)
3. Front header trim (See FRONT HEADER TRIM REMOVAL/INSTALLATION .)
4. Map light (See MAP LIGHT REMOVAL/INSTALLATION .)
Verify that the continuity between the map light terminals is as indicated in the table.

Courtesy of MAZDA MOTORS CORP.

Courtesy of MAZDA MOTORS CORP.

If not as indicated in the table, replace the map light bulb or the map light. (See MAP LIGHT BULB REMOVAL/INSTALLATION .) (See MAP LIGHT REMOVAL/INSTALLATION .)