LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly >> No. 4 Engine Mount >> Notes

No. 4 Engine Mount: Notes

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Slots have been adopted for the No. 4 engine mount bracket installation holes. If the No. 4 engine mount bracket is deviated from the original position when installing the No. 4 engine mount bracket, engine noise or vibration could increase. Before removing the No. 4 engine mount bracket, place alignment marks on the No. 4 engine mount bracket so that they can be assembled to the same positions as before removal.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
  2. Remove the following parts as a single unit: (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION ).
    • Air hose
    • Air cleaner cover
    • Air cleaner element
    • Air cleaner case
    • Fresh-air duct
  3. Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION ).
  4. Remove in the order indicated in the table.
  5. Install in the reverse order of removal.
    Fig 1: No. 4 Engine Mount Rubber And Bracket Components With Torque Specification
    G13671679Courtesy of MAZDA MOTORS CORP.
    PART SPECIFICATION

    1 No. 4 engine mount rubber
    (See No. 4 engine mount rubber removal note  ).
    (See No. 4 engine mount rubber installation note  ).
    2 No. 4 engine mount bracket
    (See No. 4 engine mount bracket removal note ).
    (See No. 4 engine mount bracket installation note ).
scientia non olet · About LEMON Manuals