No. 4 engine mount rubber removal note

WARNING: This page is about a different variant/trim than selected.

Loosen the battery tray bracket installation bolts.

Courtesy of MAZDA MOTORS CORP.
Set the front wiring harness protector No. 2 aside from the body. (See RELAY AND FUSE BLOCK REMOVAL/INSTALLATION ).

Courtesy of MAZDA MOTORS CORP.
Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION ).
CAUTION:
- To prevent damage to the transaxle, support the transaxle using the following methods.
  - Place rubber of appropriate size (approx. 20 mm {0.79 in} thickness) on a batten which is large enough to cover and support the oil pan.
Courtesy of MAZDA MOTORS CORP.
Before removing the No. 4 engine mount rubber, support the transaxle using a commercially available engine lifter or garage jack.
Remove the No. 4 engine mount rubber.