Automatic Transaxle Fluid (ATF) Replacement

WARNING: This page is about a different car, the 2020 Mazda CX-30. However, it is still accessible from the selected car via links, so may be relevant.

Replacement Part

Washer

Quantity: 1

Location of use: Drain plug

Oil and Chemical Type

ATF

Type: ATF FZ

WARNING:

Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury.

Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
Remove the front under cover No. 1. (See FRONT UNDER COVER No. 1 REMOVAL/INSTALLATION .)
Remove the dipstick securing bolt.

Courtesy of MAZDA MOTORS CORP.
Remove the dipstick.
Remove the drain plug and washer, and drain the ATF.

Fig 1: Drain Plug With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Install a new washer and drain plug.

Add ATF from the dipstick installation hole.

NOTE:

The ATF color is blue.
Only use ATF FZ.

ATF type	Resupply amount (Reference)
ATF FZ	ATF is drained from drain plug: 3.2 L {3.4 US qt, 2.8 Imp qt}

Adjust the ATF level.
Insert the dipstick and install the securing bolt.

Fig 2: Dipstick Securing Bolt With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Install the front under cover No. 1. (See FRONT UNDER COVER No. 1 REMOVAL/INSTALLATION .)
Install the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)