LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Control System - Auto A/C) >> Air Intake Actuator Removal/Installation (Auto A/C)

Air Intake Actuator Removal/Installation (Auto A/C)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  2. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
  3. Remove the following parts (with center display) (with Bluetooth® system):
    1. Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
    2. Front scuff plate (passenger-side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    3. Front side trim (passenger-side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    4. Tuner and amp unit (TAU) (with center display) (See TUNER AND AMP UNIT (TAU) REMOVAL/INSTALLATION .)
    5. Bluetooth ® unit (with Bluetooth ® system) (See Bluetooth® UNIT REMOVAL/INSTALLATION .)
  4. Disconnect the air intake actuator connector.
    Fig 1: Disconnecting Air Intake Actuator Connector
    G11529286Courtesy of MAZDA MOTORS CORP.
  5. Remove the screws, then remove the air intake actuator.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals