LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Security And Locks) >> Fuel-Filler Lid Opener And Lever Removal/Installation >> Fuel-filler Lid Opener >> Hatchback (5HB)

Hatchback (5HB)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
    2. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    4. Tire house trim (LH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    5. Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION .)
    6. Trunk side upper trim (LH) (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION .)
  2. Pull back the trunk side trim (LH) to a position which allows for the removal of the fuel-filler lid opener. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  3. Open the fuel-filler lid.
  4. Remove the nut.
    Fig 1: Locating Fuel-Filler Lid Nut
    G09077004Courtesy of MAZDA MOTORS CORP.
  5. While pressing the tabs of the stopper bracket in the direction of arrow (1) shown in the figure, press it in the direction of arrow (2) to detach it from the body.
    Fig 2: Pressing Tabs Of Stopper Bracket
    G11467703Courtesy of MAZDA MOTORS CORP.
  6. Detach all the stopper bracket tabs from the body and remove the stopper bracket.
  7. Remove the fuel-filler lid opener in the direction of the arrow.
    Fig 3: Removing Fuel-Filler Lid Opener
    G11467704Courtesy of MAZDA MOTORS CORP.
  8. Disconnect the fuel-filler lid opener cable from the fuel-filler lid opener.
    Fig 4: Disconnecting Fuel-Filler Lid Opener Cable From Fuel-Filler Lid Opener
    G11467701Courtesy of MAZDA MOTORS CORP.
  9. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals