LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> On-Board Diagnostic [HVAC System - Full-Auto Air Conditioner System] >> DTC B1086:71 [Full-Auto Air Conditioner] >> Diagnostic Procedure

Diagnostic Procedure

STEP INSPECTION ACTION
1 INSPECT AIRFLOW MODE ACTUATOR CONNECTOR 
  • Switch the ignition to off.
  • Disconnect the negative battery cable.
  • Disconnect the airflow mode actuator connector.
  • Inspect the connector and terminals (corrosion, damage, pin disconnection).
  • Are the connector and terminals normal?
 Yes Go to the next step.
No Repair/replace the connector or terminal.
After repair procedure, go to the next step.
2 INSPECT AIRFLOW MODE ACTUATOR OPERATION 
  • Disconnect the airflow mode actuator connector.
  • Apply battery positive voltage and connect the ground to the airflow mode actuator terminals F and D, and then inspect the airflow mode actuator.
  • Does the airflow mode actuator operate?
 Yes Connect the connector, then go to Step 4.
No Go to the next step.
3 INSPECT AIRFLOW MODE MAIN LINK OPERATION 
  • Remove the airflow mode actuator.
  • Operate the airflow mode main link manually.
  • Does the airflow mode main link operate smoothly?
 Yes Replace the airflow mode actuator.
(See AIRFLOW MODE ACTUATOR REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER] .)
Go to the next step.
No Replace the airflow mode main link, airflow mode sub link, and the airflow mode crank.
Go to the next step.
4 INSPECT AIRFLOW MODE ACTUATOR CIRCUIT FOR OPEN CIRCUIT OR SHORT TO GROUND 
  • Disconnect the climate control unit connector.
  • Apply battery positive voltage and connect the ground to the climate control unit connector terminals 1H and 1J, and then inspect the airflow mode actuator.
  • Does the airflow mode actuator operate?
 Yes Go to the next step.
No Repair/replace the malfunctioning vehicle wiring harness.
After repair procedure, go to the next step.
5 VERIFY CLIMATE CONTROL UNIT CONNECTOR CONDITION 
  • Inspect the connector and terminals (corrosion, damage, pin disconnection).
  • Are the connector and terminals normal?
 Yes Go to the next step.
No Repair/replace the malfunctioning vehicle wiring harness, connector, or terminal.
After repair procedure, go to the next step.
6 VERIFY THAT SAME DTC IS NOT OUTPUT AGAIN  Yes Repeat the inspection from Step 1.
Go to the next step.
No Go to the next step.
7 VERIFY THAT NO OTHER DTCs ARE PRESENT 
  • Verify other DTCs displayed.
  • Are any other DTCs output?
 Yes Perform the corresponding DTC inspection.
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals