LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Control System [HVAC - Full Auto Air Conditioner) >> Rear Vent Actuator Removal/Installation [Full-Auto Air Conditioner] >> Notes

Rear Vent Actuator Removal/Installation [Full-Auto Air Conditioner]: Notes

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    2. Center console box (See CENTER CONSOLE BOX REMOVAL/INSTALLATION .)
    3. Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION .)
    4. Center console (See CENTER CONSOLE REMOVAL/INSTALLATION .)
    5. Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R] .)
    6. Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
    7. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    8. Front console (See FRONT CONSOLE REMOVAL/INSTALLATION .)
    9. Rear heat duct (2) (See REAR HEAT DUCT REMOVAL/INSTALLATION .)
    10. Dashboard bracket (See DASHBOARD REMOVAL/INSTALLATION .)
  3. Remove the screws. (See SCREW REMOVAL NOTE .)
    Fig 1: Rear Vent Actuator Connector, Rear Vent Actuator And Screw
    G08150943
  4. Disconnect the rear vent actuator connector.
  5. Remove the rear vent actuator.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals