Snapshot data table
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Refer to PID Monitor Table for confirm the transaxle control system operation status while the TCM does not store the DTC. (See ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION .)
- Snapshot data items are not displayed, according to detected DTC.
| Snap shot data item | Unit | Data contents | Corresponding data monitor items |
|---|---|---|---|
| LOAD | % | Charging efficiency | LOAD |
| ECT | °C {°F} | Engine coolant temperature | ECT |
| RPM | RPM | Engine speed | RPM |
| VSS | KPH {MPH} | Vehicle speed | VSS |
| TP1 | % | Throttle position sensor | THOP |
| EG_RUN_TIME | hh:mm:ss | Time since engine start | - |
| VPWR | V | Power supply voltage | VPWR |
- 3. Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
- 4. After completion of repairs, clear all DTCs stored in the TCM. (See CLEARING DTCS PROCEDURE .)