LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 627 (Body System [Doors And Liftgate]) >> Front Door Pad Removal/Installation

Front Door Pad Removal/Installation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}  .
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Inner garnish. See INNER GARNISH REMOVAL/INSTALLATION .
    2. Front door trim. See FRONT DOOR TRIM REMOVAL/INSTALLATION .
    3. Front door speaker. See FRONT DOOR SPEAKER REMOVAL/INSTALLATION .
    4. Front door glass. See FRONT DOOR GLASS REMOVAL/INSTALLATION .
    5. Front door module panel. See FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION .
    Fig 1: Identifying Distance From Top Of Front Door Glass To Upper Part Of Front Beltline Molding
    G06205691Courtesy of MAZDA MOTORS CORP.
  4. Remove the fasteners.
  5. Remove the front door pad.
  6. Install in the reverse order of removal.
Fig 2: Identifying Front Door Pad And Fastener
G06205692Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals