Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	PERFORM DTC INSPECTION Clear the DTC from the memory. See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Switch the ignition to ON. Perform the DTC inspection using the M-MDS. See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Is the same DTC present?	Yes	Replace and configure the instrument cluster, then go to the next step. See INSTRUMENT CLUSTER REMOVAL/INSTALLATION . See INSTRUMENT CLUSTER CONFIGURATION .
1		No	Go to the next step.
2	VERIFY AFTER REPAIR PROCEDURE Drive the vehicle at speed of more than 25 km/h {15.5 mph} for more than 10 min . Are any DTCs present?	Yes	Go to the applicable DTC inspection. See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .
2		No	DTC troubleshooting completed.