Diagnostic Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC PROCEDURE CHART

STEP	INSPECTION		ACTION
1	VERIFY PROGRAMED ID Switch the ignition to off. Connect the M-MDS to the DLC-2. Select the following PIDs using the M-MDS. WU1_ID WU2_ID WU3_ID WU4_ID Switch the ignition to ON. Is the same code in the output ID?	Yes	Configure the instrument cluster, then go to the next step. See INSTRUMENT CLUSTER CONFIGURATION .
1		No	Go to the next step.
2	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from the memory See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Drive the vehicle at speed of more than 25 km/h {15.5 mph} for more than 10 min. Perform the DTC inspection using the M-MDS See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS . Is the same DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace and configure the instrument cluster, then go to the next step. See INSTRUMENT CLUSTER REMOVAL/INSTALLATION . See INSTRUMENT CLUSTER CONFIGURATION .
2		No	Go to the next step.
3	VERIFY AFTER REPAIR PROCEDURE Drive the vehicle at speed of more than 25 km/h {15.5 mph} for more than 10 min. Are any DTCs present?	Yes	Go to the applicable DTC inspection. See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .
3		No	DTC troubleshooting completed.