Diagnostic Procedure
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM ABS/TCS HU/CM OR DSC HU/CM DTC INSPECTION
|
Yes | Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [ABS/TCS] .) (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) |
| No | Go to the next step. | ||
| 2 | PERFORM INSTRUMENT CLUSTER DTC INSPECTION
|
Yes | Replace the ABS/TCS HU/CM or DSC HU/CM, then go to the next step. (See ABS/TCS HU/CM REMOVAL/INSTALLATION .) (See DSC HU/CM REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY TROUBLESHOOTING COMPLETED
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY THAT NO OTHER DTCs ARE RECORDED
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | DTC troubleshooting completed. | ||