LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 558 (On-Board Diagnostic [Instrument Cluster)) >> DTC Table [Instrument Cluster]

DTC Table [Instrument Cluster]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC Malfunction location Reference
B10D5:13(1)
  • Coil antenna malfunction
  • PCM determined a malfunction in coil antenna even though it is normal
(See SECURITY LIGHT: 12, DTC: B10D5:13/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10D7:05(1) Key ID number program error (See SECURITY LIGHT: 13, DTC: B10D7:05/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10D7:51(1) Instrument cluster has detected unprogrammed key ID number (See SECURITY LIGHT: 15, DTC: B10D7:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10D7:81(1) Instrument cluster cannot read key ID number data normally (See SECURITY LIGHT: 14, DTC: B10D7:81/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10D7:94(1) Key ID number data cannot be read (See SECURITY LIGHT: 13, DTC: B10D7:94/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10D8:00(1) Only one key or no key has been programmed (See SECURITY LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10D9:87(1) No detected communication with coil antenna (See SECURITY LIGHT: 11, DTC: B10D9:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10DA:51(1) Communication error between instrument cluster and PCM (data transfer failure) (See SECURITY LIGHT: 22, DTC: B10DA:51/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
B10DA:62(1) ID number data in instrument cluster and PCM do not match (See SECURITY LIGHT: 23, DTC: B10DA:62/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
C0077:00(3) Low tire pressure (See DTC C0077:00 .)
C2011:49(3) Wheel unit No 1 internal malfunction (See DTC C2011:49/C2012:49/C2013:49/C2014:49 .)
C2012:49(3) Wheel unit No 2 internal malfunction
C2013:49(3) Wheel unit No 3 internal malfunction
C2014:49(3) Wheel unit No 4 internal malfunction
C2011:87(3) Wheel unit No 1 (No response) (See DTC C2011:87/C2012:87/C2013:87/C2014:87 .)
C2012:87(3) Wheel unit No 2 (No response)
C2013:87(3) Wheel unit No 3 (No response)
C2014:87(3) Wheel unit No 4 (No response)
P0070:14 Ambient temperature sensor circuit malfunction (See DTC P0070:14 [INSTRUMENT CLUSTER] )
U0001:88 Module communication error (HS-CAN) (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] .)
U0010:88 Module communication error (MS-CAN)
U0100:00 PCM communication error
U0100:87(1) Communication error between the instrument cluster and the PCM (no response) (See SECURITY LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .)
U0101:00(4) TCM communication error (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] .)
U0121:00 ABS/TCS HU/CM communication error (With ABS/TCS) DSC HU/CM communication error (With DSC)
U0127:00(3) Communication failure between instrument cluster and keyless receiver (See DTC U0127:00 .)
U0131:00 EPS control module communication error (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] .)
U0140:00 BCM communication error
U0151:00 SAS control module communication error
U0164:00(5) Heater control module communication error
U0214:00(2) Keyless control module communication error
U0233:00(6) BSM control module (RH) communication error
U0300:00 Instrument cluster configuration error (See DTC U0300:00 [INSTRUMENT CLUSTER] .)
U0401:68 Signal error from PCM (See DTC U0401:68 [INSTRUMENT CLUSTER] .)
U0401:92 Illumination command signal from PCM continues for 20 s or more  (See DTC U0401:92 [INSTRUMENT CLUSTER] .)
U0402:68(4) Signal error from TCM (See DTC U0402:68 [INSTRUMENT CLUSTER] .)
U0402:92(4) On request from TCM (See DTC U0402:92 [INSTRUMENT CLUSTER] .)
U0415:68 Signal error from ABS/TCS HU/CM or DSC HU/CM (See DTC U0415:68 [INSTRUMENT CLUSTER] .)
U0415:92 On request from ABS/TCS HU/CM or DSC HU/CM (See DTC U0415:92 [INSTRUMENT CLUSTER] .)
U0452:92 On request from SAS control module (See DTC U0452:92 [INSTRUMENT CLUSTER] .)
U0515:68(2) Signal error from keyless control module (See DTC U0515:68 [INSTRUMENT CLUSTER] .)
U0515:92(2) On request from keyless control module (See DTC U0515:92 [INSTRUMENT CLUSTER] .)
U2005:86 Signal error from PCM (See DTC U2005:86 [INSTRUMENT CLUSTER] .)
U2100:00 Instrument cluster configuration error (See DTC U2100:00 [INSTRUMENT CLUSTER] .)
U3000:41 Instrument cluster internal malfunction (See DTC U3000:41 [INSTRUMENT CLUSTER] .)
U3000:42(3) ID registration failure (See DTC U3000:42 .)
U3003:16 Instrument cluster power supply voltage is low (See DTC U3003:16 [INSTRUMENT CLUSTER] .)
(1) Vehicles with keyless entry system
(2) Vehicles with advanced keyless entry and push button start system
(3) Vehicles with tire pressure monitoring system
(4) ATX
(5) Vehicles with full-auto A/C
(6) Vehicles with BSM