LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Fuel System [MZR 2.5]) >> Fuel Injector Removal/Installation >> Notes

Fuel Injector Removal/Installation: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Complete the "BEFORE SERVICE PRECAUTION". (See BEFORE SERVICE PRECAUTION .)
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
  4. Disconnect the fuel injector connector.
  5. Remove in the order indicated in the table.
    FUEL INJECTOR COMPONENTS REMOVAL SEQUENCE

    1 Quick release connector
    (See QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION .)
    2 Fuel distributor
    3 Injector clip
    (See FUEL INJECTOR REMOVAL NOTE .)
    4 Fuel injector
    (See FUEL INJECTOR INSTALLATION NOTE .)
  6. Install in the reverse order of removal.
  7. Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION .)
Fig 1: Fuel Injector Components Removal Sequence
G07620564Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals