LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Fuel System [MZR 2.5]) >> Fuel Injector Removal/Installation >> Fuel Injector Removal Note

Fuel Injector Removal Note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Use of a deformed injector clip will cause the fuel injector to be connected incorrectly and could result in fuel leakage. It will also cause the injector to rotate. Therefore, always replace the clip when the injector is removed.
  1. Insert a flathead screwdriver between the injector cup and clip finger.
    Fig 1: Inserting Flathead Screwdriver Between Injector Cup And Clip Finger
    G07620565Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • When pushing the clip finger outward, deform the finger until it is removed completely from the cup notch.
  2. Push the clip finger outward using a flathead screwdriver.
  3. Remove the injector with the clip.
    Fig 2: Clip Finger And Notch
    G07620566Courtesy of MAZDA MOTORS CORP.
  4. Remove the clip from the fuel injector using the following procedure:
NOTE:
  • The clip will not be reused.
  1. Hold the clip using pliers.
  2. Pull the clip parallel to the injector groove and remove it from the injector.
Fig 3: Removing Clip From Fuel Injector
G07620567Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals