LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Automatic Transaxle [Service, Removal & Installation FS5A-El)) >> Transaxle Fluid Temperature (TFT) Sensor Removal/Installation

Transaxle Fluid Temperature (TFT) Sensor Removal/Installation

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing the ATF.
  1. Disconnect the negative battery cable.
  2. Remove the under cover.
  3. Drain the ATF.
  4. Remove the oil pan.
  5. Remove the primary control valve body. (See PRIMARY CONTROL VALVE BODY REMOVAL ).
  6. Remove the coupler component.
  7. Install the coupler component.
  8. Install the primary control valve body. (See PRIMARY CONTROL VALVE BODY REMOVAL ).
  9. Install the oil pan. (See PRIMARY CONTROL VALVE BODY REMOVAL ).
  10. Install the under cover.
  11. Connect the negative battery cable.
  12. Add ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT ).
  13. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST ).
    Fig 1: TFT Sensor
    G04326240Courtesy of MAZDA MOTORS CORP.
  14. Perform the road test. (See ROAD TEST ).
scientia non olet · About LEMON Manuals