Automatic Transaxle Fluid (ATF) Replacement
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When the transaxle and ATF are hot, they can badly burn you. Turn off the engine and wait until they are cool before changing the ATF.
- Remove the oil dipstick.
- Remove the oil drain plug and washer.
- Drain the ATF into a container.
- Install a new washer and drain plug.
Tightening torque
29.4-41.2 N.m {3.0-4.2 kgf.m, 22-30 ft.lbf}
- Add the specified ATF until ATF level reaches lower notch of dipstick type of ATF through the oil filler tube.
ATF type
ATF M-V
Capacity (approx. quantity)
Draining ATF from drain plug: 3.0 L {3.2 US qt, 2.4 Imp qt}
Overhauling ATX: 5.0 L {5.3 US qt, 4.4 Imp qt}
- Adjust the ATF amount to within the specified range according to the ATF inspection procedure. (See
AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION ).NOTE:
- The full amount of ATF for the ATX is as follows
Capacity (approx. quantity)
8.14 L {8.6 US qt, 7.2 Imp qt}