LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Lighting System >> Rear Combination Light Removal/Installation

Rear Combination Light Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  3. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  4. Remove in the order indicated.
    Fig 1: Removing Order Of Rear Combination Light
    G01344555Courtesy of MAZDA MOTORS CORP.
    Fig 2: Removing/Installing Rear Combination Light
    G01344556Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals