Pinpoint Test P : RDU (Rear Drive Unit) Motor Phase Circuits
WARNING: This page is about a different variant/trim than selected.
- P1 INSPECT THE AWD (ALL-WHEEL DRIVE) MODULE AND RDU MOTOR CONNECTORS FOR CONTAMINATION
- Ignition OFF.
- Disconnect AWD C3841.
- Disconnect RDU C4371A.
- INSPECT the connectors for water intrusion, bent pins, spread terminals, corrosion, or damage.
Is any damage or contamination present?
Yes REPAIR as necessary. CLEAR DTC and PERFORM KOER self-test. No GO to P2 - P2 CHECK THE AWD (ALL-WHEEL DRIVE) MOTOR CIRCUITS FOR AN OPEN
- Ignition OFF.
- Disconnect AWD C3841.
- Disconnect RDU C4371A.
- Measure:
Positive Lead Measurement / Action Negative Lead C4371A-1 C3841-3 C4371A-2 C3841-2 C4371A-3 C3841-30
Are the resistances less than 3 ohms?
Yes GO to P3 No REPAIR the circuit. - P3 CHECK THE AWD (ALL-WHEEL DRIVE) MOTOR CIRCUITS FOR A SHORT TO GROUND
- Ignition OFF.
- Disconnect AWD C3841.
- Disconnect RDU C4371A.
- Measure:
Positive Lead Measurement / Action Negative Lead C3841-3 Ground C3841-2 Ground C3841-30 Ground
Are the resistances greater than 10, 000 ohms?
Yes GO to P4 No REPAIR the circuit. - P4 CHECK THE AWD (ALL-WHEEL DRIVE) MOTOR CIRCUITS FOR A SHORT TOGETHER
- Ignition OFF.
- Disconnect AWD module C3841.
- Disconnect RDU C4371A.
- Measure:
Positive Lead Measurement / Action Negative Lead C3841-3 C3841-2 C3841-2 C3841-30 C3841-3 C3841-30
Are the resistances greater than 10, 000 ohms?
Yes GO to P5 No REPAIR the circuit. - P5 VERIFY CONCERN
- Ignition OFF.
- Ignition ON.
- Enter diagnostic test mode: AWD Module Self Test.
- Erase AWD Module CMDTCs.
- Road test vehicle:
- 1. Accelerate from 0-30 MPH three times.
- 2. Steady cruise above 45 MPH for 30 seconds
- 3. Slow to a stop.
- 4. Ignition Off.
- 5. Repeat road test 2 times.
- Road test vehicle:
- Retrieve AWD Module CMDTC
Did C0095:xx set in the continuous memory
Yes INSTALL a new RDU. REFER to: Axle Assembly . No The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or terminal issues.