Removal and Installation
NOTE:
If installing a new roof opening panel frame, the following components will need to be transferred from the original assembly: concertina blinds, roof opening panel glass, roof opening panel air deflector, roof opening panel trough, roof opening panel shield, roof opening panel motor, front and rear drain hoses.
- Remove the roof opening panel glass. Refer to Roof Opening Panel Glass .
- If installing a new roof opening panel frame, transfer all components from the original assembly to be installed on the new opening panel frame. Refer to Roof Opening Panel - Exploded View .
- Remove the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the 4 roof opening panel drain hoses.
- Disconnect the electrical connector.
- Remove the 8 roof opening panel frame bolts and remove the roof opening panel frame.
- To install tighten to 12 Nm (106 lb-in).
- To install, reverse the removal procedure.
- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization .