Roof Opening Panel Glass
- Open the roof opening panel to the VENT position.
- Remove the 4 roof opening panel glass screws.
- To access the glass screws, unclip the top portion of the concertina blind and position aside as shown in illustration.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.
- Verify that the roof opening panel glass is centered and aligned before tightening the roof opening panel glass screws. For additional information, refer to Roof Opening Panel Alignment .
- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization .