LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 250 FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case System - Service Information) >> TRANSFER CASE FRONT OIL SEAL (for RH Side) >> Replacement [11/2021 - 03/2024] >> Procedure

Replacement [11/2021 - 03/2024]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH 
  2. REMOVE DRIVE SHAFT BEARING BRACKET 
  3. REMOVE TRANSFER CASE OIL SEAL RH 
    1. Using SST, remove the transfer case oil seal RH from the transfer assembly.
      • SST: 09308-00010 
      NOTE:

      Do not scratch the press-fitting surface of the transfer case oil seal RH.

      GTY1062311Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transfer Case Oil Seal RH
  4. INSTALL TRANSFER CASE OIL SEAL RH 
    1. Coat the lip of a new transfer case oil seal RH with MP grease.
    2. Using SST and a hammer, tap in the transfer case oil seal RH to the transfer assembly as shown in the illustration.
      GTY1062914Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transfer Case Oil Seal RH
      • SST: 09631-32020 
      • SST: 09950-60021 
        1. 09951-00680
      • SST: 09950-70010 
        1. 09951-07360

      Drive in Depth (A)

      7.5 to 8.5 mm (0.296 to 0.334 in.)

      NOTE:
      • Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
      • Do not tap the transfer case oil seal RH in too far.
  5. INSTALL DRIVE SHAFT BEARING BRACKET 
  6. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH 
scientia non olet · About LEMON Manuals