LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System - Service Information) >> AIR FUEL RATIO SENSOR (for Bank 2 Sensor 2) >> Removal [12/2023 - ] >> Procedure

Removal [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 7

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 8

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9

  4. REMOVE SUSPENSION TOWER DAMPER 
    Refer to PROCEDURE - Step 4
  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY 
    Refer to PROCEDURE - Step 5
  6. REMOVE FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 7
  7. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 2) 
    1. GTY1240285Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using SST, remove the air fuel ratio sensor from the front No. 2 exhaust pipe sub-assembly.
        • SST: 09224-00012 
        NOTE:

        If the air fuel ratio sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals