Removal [03/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 2 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 2 [05/2023 - 09/2023] , or refer to PROCEDURE - Step 2 [09/2023 - ]
REMOVE RADIATOR SUPPORT TO FRAME SEAL LH
Refer to PROCEDURE - Step 2 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 2 [05/2023 - ]
REMOVE RADIATOR SUPPORT TO FRAME SEAL RH
Refer to PROCEDURE - Step 1 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 1 [05/2023 - ]
REMOVE LOWER RADIATOR AIR DEFLECTOR
Refer to PROCEDURE - Step 3 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 3 [05/2023 - ]
DISCONNECT NO. 2 PCV HOSE
Refer to PROCEDURE - Step 6
DISCONNECT NO. 3 PCV HOSE
Refer to PROCEDURE - Step 7
REMOVE AIR CLEANER HOSE ASSEMBLY
Refer to PROCEDURE - Step 8
REMOVE INTAKE AIR CONNECTOR PIPE
Refer to PROCEDURE - Step 8 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 8 [05/2023 - 09/2023] , or refer to PROCEDURE - Step 8 [09/2023 - ]

REMOVE FAN AND GENERATOR V BELT

Release the fan and generator V belt tension by turning the V-ribbed belt tensioner assembly counterclockwise and remove the fan and generator V belt from the V-ribbed belt tensioner assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Turn in this Direction

NOTE:

Left-hand thread pulley set bolts are used so loosen the pulley set bolts by turning clockwise.

Rotate the V-ribbed belt tensioner assembly counterclockwise to align the holes and then insert a 5 mm bi-hexagon wrench to secure the V-ribbed belt tensioner assembly in place.

*a	5 mm Bi-hexagon Wrench
*b	Hole

Remove the fan and generator V belt.