LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> LX 570 >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (Service Information) >> Engine Oil Cooler >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - ] ).

  3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 1

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH 

    Refer to PROCEDURE - Step 2

  5. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 3

  6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  7. DRAIN ENGINE OIL 

    See step  1 [09/2015 - 08/2020], or see step  1 [08/2020 - ]

  8. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 5

  9. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

  10. REMOVE FAN & GENERATOR V BELT 

    Refer to PROCEDURE - Step 6

  11. REMOVE OIL FILTER ELEMENT 

    See step  4 [09/2015 - 08/2020], or see step  4 [08/2020 - ]

  12. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY 

    See step  5

  13. DISCONNECT COOLER COMPRESSOR ASSEMBLY 

    See step  21

  14. REMOVE NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY 
    1. GTY611522Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 3 bolts.

    2. Disconnect the 4 hoses and remove the water by-pass pipe.
  15. REMOVE NO. 1 OIL COOLER BRACKET 
    1. GTY593094Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 2 nuts and bracket.

    2. Disconnect the ground wire from the cylinder block.
  16. REMOVE OIL FILTER BRACKET 
    1. GTY604891Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 2 bolts, 2 nuts and filter bracket.

    2. GTY604897Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 2 O-rings.

  17. REMOVE OIL COOLER ASSEMBLY 
    1. GTY610800Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 5 nuts and oil cooler from the oil filter bracket.

    2. GTY571706Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the 2 O-rings.

  18. REMOVE OIL COOLER SPACER 
    1. GTY571704Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the bolt and oil cooler spacer from the oil filter bracket.

    2. GTY603077Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Remove the gasket.

scientia non olet · About LEMON Manuals