Removal [09/2015 - ]: Procedure
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).
- REMOVE UPPER RADIATOR SUPPORT SEAL
Refer to PROCEDURE - Step 3
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - ] ).
- REMOVE INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 25
- REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 13
- REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 2
- REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 1
- REMOVE NO. 1 SWITCH HOLE BASE
Refer to PROCEDURE - Step 14
- REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 15
- REMOVE INSTRUMENT PANEL MOULDING SUB-ASSEMBLY
Refer to PROCEDURE - Step 26
- REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET
- REMOVE NO. 1 RADIO BRACKET
- REMOVE NO. 2 RADIO BRACKET