Installation [07/2020 - 05/2023]: Procedure
- INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
- INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 25 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 25 [10/2022 - 05/2023]
- INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 26 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 26 [10/2022 - 05/2023]
- INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
Refer to PROCEDURE - Step 27 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 27 [10/2022 - 05/2023]
- INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
- Move the upper console panel sub-assembly to the installation position diagonally at a slightly slanted angle from the rear upper of the vehicle.NOTE:
Hold the areas shown in the illustration, lift the upper console panel sub-assembly and while inserting a portion of the claw into the mating hole move it to the installation position.
Place Hands Here Install in this Direction (1) Install in this Direction (2) - Attach the claw.
- Slide toward the front of the vehicle to insert the guide and attach the claw.
Install in this Direction - Fold the front seatback (RH side) forward and attach the clip and claw.
- Return the front seatback (RH side) to the original position and install the bolt.
- Install the upper console panel sub-assembly with the 2 bolts and 2 screws.
Bolt Screw
- Move the upper console panel sub-assembly to the installation position diagonally at a slightly slanted angle from the rear upper of the vehicle.
- INSTALL BOX PANEL SUB-ASSEMBLY
- INSTALL NO. 1 GLOVE COMPARTMENT PANEL
Refer to PROCEDURE - Step 29 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 29 [10/2022 - 05/2023]
- INSTALL UPPER CONSOLE BOX
Refer to PROCEDURE - Step 6
- INSTALL SHIFTING HOLE COVER ASSEMBLY
Refer to PROCEDURE - Step 9
- INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
- INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
Refer to INSTALLATION [07/2020 - ]
- INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 30 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 30 [10/2022 - 05/2023]
- INSTALL FRONT DOOR NO. 2 OPENING TRIM COVER LH
Refer to PROCEDURE - Step 31 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 31 [10/2022 - 05/2023]
- INSTALL FRONT DOOR OPENING TRIM COVER LH
Refer to PROCEDURE - Step 33 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 33 [10/2022 - 05/2023]
- INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 35 [07/2020 - 10/2022] , or refer to PROCEDURE - Step 35 [10/2022 - 05/2023]