LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2020 >> UX 200 Luxury >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension (Rear) (Service Information) >> REAR LOWER ARM (for 2WD) >> Removal [10/2018 - 07/2022] >> Procedure

Removal [10/2018 - 07/2022]: Procedure

  1. REMOVE REAR WHEEL 

    Refer to REMOVAL [10/2018 - ]

  2. REMOVE REAR FLOOR SIDE MEMBER COVER LH (for LH Side) 

    Refer to PROCEDURE - Step 3

  3. REMOVE NO. 1 FLOOR UNDER COVER ASSEMBLY (for RH Side) 

    Refer to PROCEDURE - Step 4

  4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor) 

    Refer to PROCEDURE - Step 1

  5. REMOVE REAR STABILIZER LINK ASSEMBLY 

    See step  4

  6. REMOVE REAR COIL SPRING 

    See step  5

  7. REMOVE REAR LOWER COIL SPRING INSULATOR 

    See step  7

  8. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY 
    1. Remove the nut, No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear No. 2 suspension arm assembly.
      NOTE:

      Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

      GTY574491Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY 
    1. Remove the 2 bolts, 2 nuts and rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly and rear suspension member sub-assembly.
      NOTE:

      Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.

      GTY609386Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals