Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL NO. 2 FUEL PRESSURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
Refer to INITIALIZATION [10/2018 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]
- Install a new O-ring to the No. 2 fuel pressure sensor.
- Install the No. 2 fuel pressure sensor to the fuel delivery pipe sub-assembly.
- Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- Connect the No. 2 fuel pressure sensor connector.
- INSTALL EGR VALVE ASSEMBLY
Refer to INSTALLATION [10/2018 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the fuel pressure sensor (fuel delivery pipe with sensor assembly).
Refer to INITIALIZATION [10/2018 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]
- Perform "Inspection After Repair" after replacing the fuel pressure sensor (fuel delivery pipe with sensor assembly).