Installation [10/2018 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus UX 250h, 2023 Lexus UX 250h, 2022 Lexus UX 250h, 2021 Lexus UX 250h, and 2020 Lexus UX 250h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL FUEL PRESSURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Refer to INITIALIZATION [10/2018 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.
*a Cutout (Fuel Delivery Pipe) *b Cutout (Fuel Pressure Sensor) NOTE:Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.
- Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe as shown in the illustration.
*a Cutout (Fuel Pressure Sensor) *b Cutout (No. 1 Fuel Pressure Sensor Holder) NOTE:Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.
- Using an 8 mm socket wrench, install the 2 bolts.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.
- INSTALL INTAKE MANIFOLD
Refer to INSTALLATION [10/2018 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Refer to INITIALIZATION [10/2018 - 08/2021] , or refer to INITIALIZATION [08/2021 - ]
- Perform "Inspection After Repair" after replacing the fuel pressure sensor.