Removal [10/2018 - 07/2022]: Procedure

REMOVE FRONT WHEEL LH
Refer to REMOVAL [10/2018 - ]
REMOVE HEADLIGHT ASSEMBLY LH
- for Triple Beam Headlight:
  Refer to REMOVAL [10/2018 - ]
- for Single Beam Headlight:
  Refer to REMOVAL [10/2018 - ]
REMOVE HIGH PITCHED HORN ASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE LOW PITCHED HORN ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE NO. 1 RADIATOR TO SUPPORT SEAL
- for Gasoline Model:
  Refer to PROCEDURE - Step 10 [10/2018 - 10/2019] Refer to PROCEDURE - Step 10 [10/2019 - 07/2022]
- for HV Model:
  Refer to PROCEDURE - Step 11 [10/2018 - 10/2019] Refer to PROCEDURE - Step 11 [10/2019 - ]

REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Remove the 2 screws, 11 clips and front fender splash shield sub-assembly LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE NO. 1 AIR CLEANER INLET
- for Gasoline Model:
  Refer to PROCEDURE - Step 11 [10/2018 - 10/2019] Refer to PROCEDURE - Step 11 [10/2019 - 07/2022]
- for HV Model:
  Refer to PROCEDURE - Step 12 [10/2018 - 10/2019] Refer to PROCEDURE - Step 12 [10/2019 - ]

REMOVE HOOD LOCK ASSEMBLY

Disconnect the connector and disengage the guide.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 3 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the guide to remove the hood lock assembly from the hood lock control cable assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 11 [10/2018 - 08/2021] Refer to PROCEDURE - Step 11 [08/2021 - 07/2022]

REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Disengage the guide to remove the hood lock control lever sub-assembly from the hood lock control cable assembly.

REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

Disengage the clamps and grommet to remove the hood lock control cable assembly.

Grommet