Removal [10/2018 - 07/2022]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to INITIALIZATION [10/2018 - 07/2022]
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
- for Gasoline Model:
Refer to REMOVAL [10/2018 - 07/2022]
- for HV Model:
Refer to REMOVAL [10/2018 - 07/2022]
WARNING:- Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2018 - 07/2022]
- for Gasoline Model:
- REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 4
- DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 9 [10/2018 - 08/2021] , or refer to PROCEDURE - Step 9 [08/2021 - 07/2022]
- REMOVE INSTRUMENT SIDE PANEL RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 10 [10/2018 - 08/2021] , or refer to PROCEDURE - Step 10 [08/2021 - 07/2022]
- REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
- REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 9
- REMOVE GLOVE BOX LIGHT ASSEMBLY