Installation [10/2017 - 10/2020]: Procedure

INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

NOTE:

Do not reuse dropped or damaged parts.

Connect the 2 connectors.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install the certification ECU (smart key ECU assembly) with the 2 nuts.

INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH
Refer to PROCEDURE - Step 6
INSTALL LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 30
INSTALL COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 31
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 34
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 32
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 33
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [10/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 10/2020]
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 11
PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [10/2017 - 10/2020]
PERFORM CODE REGISTRATION
Refer to REGISTRATION [10/2017 - 10/2020]
CHECK SRS WARNING LIGHT
Refer to OPERATION CHECK [10/2017 - 10/2020]