Installation [12/2017 - 10/2020]: Procedure

INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Check that the cable is disconnected from the negative (-) battery terminal.

WARNING:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Lock Button
	Push

While holding the lower No. 2 instrument panel airbag assembly with one hand, connect the airbag connector and push the lock button to lock it.

NOTE:

When connecting any airbag connector, take care not to damage the airbag wire harness.
Make sure the lock button is securely locked.

Attach the claw to install the lower No. 2 instrument panel airbag assembly.

Install in this Direction

Install the 2 bolts.

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)

INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH
Refer to PROCEDURE - Step 7
INSTALL COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 35
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 36
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 37
INSTALL FRONT DOOR SCUFF PLATE RH
Refer to PROCEDURE - Step 43
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 10/2020]
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 11
PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [12/2017 - 10/2023]
CHECK SRS WARNING LIGHT
Refer to OPERATION CHECK [12/2017 - 11/2021]