Installation [12/2017 - 10/2020]: Procedure

1. Lower the battery along the slope to install it as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Install battery in this direction
   *a	Slope

   NOTE:

   As the battery is very heavy, handle it with caution. If it is dropped or subjected to any strong impacts, replace it with a new one.

2. Install the battery.
3. Connect the battery exhaust hose to the battery.
   NOTE:

   After replacing the battery, install the ventilation hole plug supplied with the new battery or the ventilation hole plug from the old battery to the ventilation hole on the side to which the battery hose is not connected.

4. Install the battery clamp sub-assembly with the 2 nuts.

   Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

5. Connect the cable to the positive (+) battery terminal and tighten the nut.

   Torque: 5.4 N.m (55 kgf/cm, 48 in.lbf) 

6. Attach the claw to connect the battery terminal cap.
7. Connect the clamp spring assembly of the positive (+) battery terminal to the battery as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Battery	*2	Clamp Spring Assembly
   	Push the clamp spring assembly in this direction	-	-

1. Connect the cable to the negative (-) battery terminal and tighten the nut.

   Torque: 6.4 N.m (65 kgf/cm, 57 in.lbf) 

   NOTE:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Refer to INITIALIZATION [12/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 10/2020]

1. Install the tool box.

Refer to PROCEDURE - Step 11