Removal [12/2017 - 10/2022]: Procedure

AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)
Refer to PRECAUTION [12/2017 - ]
REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 20 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 20 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 20 [10/2020 - 10/2022]
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 22 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 22 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 22 [10/2020 - 10/2022]
REMOVE STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY
Refer to PROCEDURE - Step 24 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 24 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 24 [10/2020 - 10/2022]
DISCONNECT BRAKE BOOSTER PUMP CONNECTOR (w/o Vacuum Brake Booster)
Refer to PROCEDURE - Step 2 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 2 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 2 [10/2020 - 10/2022]
REMOVE FRONT WHEEL
Refer to REMOVAL [12/2017 - 10/2023]
DISCONNECT FRONT SPEED SENSOR
Refer to PROCEDURE - Step 7
DISCONNECT DISC BRAKE CYLINDER ASSEMBLY
Refer to PROCEDURE - Step 8
REMOVE FRONT DISC LH
- for 6-Pot Caliper:
  Refer to PROCEDURE - Step 8
- except 6-Pot Caliper:
  Refer to PROCEDURE - Step 9
REMOVE FRONT AXLE SHAFT LH NUT
Refer to PROCEDURE - Step 10
REMOVE FRONT DISC BRAKE DUST COVER LH
Refer to PROCEDURE - Step 11
DISCONNECT TIE ROD ASSEMBLY LH
Refer to PROCEDURE - Step 16 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 16 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 16 [10/2020 - 10/2022]

LOOSEN FRONT SUSPENSION LOWER ARM ASSEMBLY LH

Loosen the 3 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

DISCONNECT FRONT SUSPENSION UPPER ARM
Refer to PROCEDURE - Step 4

REMOVE STEERING KNUCKLE LH

Remove the 3 bolts and steering knuckle LH..

REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 16
REMOVE DISC BRAKE AIR GUIDE PLATE
1. Remove the disc brake air guide plate from the steering knuckle LH.