LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2019 >> ES 350 Luxury >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Door / Hatch - Service Information (1 Of 2) >> Hood Lock Control Cable Assembly >> Removal [06/2018 - 08/2020] >> Procedure

Removal [06/2018 - 08/2020]: Procedure

  1. REMOVE FRONT WHEEL LH 

    Refer to PROCEDURE - Step 1

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    HINT: 

    Use the same procedure as for the RH side.

    Refer to PROCEDURE - Step 2

  3. REMOVE REAR FENDER SPLASH SHIELD SUB-ASSEMBLY LH 

    HINT: 

    Use the same procedure as for the RH side.

    Refer to PROCEDURE - Step 3

  4. REMOVE PIN HOLD CLIP 

    HINT: 

    Use the same procedure as for the RH side.

    Refer to PROCEDURE - Step 4

  5. REMOVE FRONT FENDER LINER RETAINER 

    Refer to PROCEDURE - Step 34

  6. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1

  7. REMOVE VEHICLE APPROACHING SPEAKER ASSEMBLY (for HV Model) 

    Refer to PROCEDURE - Step 2

  8. REMOVE HOOD LOCK ASSEMBLY 
    1. except TMMK Made Gasoline Model:
      1. Disconnect the connector.
        GTY802312Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for TMMK Made Gasoline Model:
      1. Disengage the clamp.
        GTY796049Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Disconnect the connector.
    3. Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap.
      GTY837806Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
    4. Remove the 2 bolts and hood lock bolt.
      GTY807226Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Hood Lock Bolt
    5. Disconnect the hood lock control cable assembly to remove the hood lock assembly.
      GTY802313Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 4

  10. REMOVE COWL SIDE TRIM BOARD LH 

    Refer to PROCEDURE - Step 5

  11. REMOVE FRONT DOOR OPENING TRIM COVER LH 

    Refer to PROCEDURE - Step 6

  12. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 14

  13. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 15

  14. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 16

  15. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
    1. Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.
      GTY802360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY 
    1. Disengage the clamp.
      GTY802362Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, disengage each clamp and the grommet as shown in the illustration.
      GTY780344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Hood Lock Control Cable Assembly - -
      *a Clamp *b Grommet

      HINT: 

      Tape the screwdriver tip before use.

    3. Pull the hood lock control cable assembly from the engine compartment to remove it.
scientia non olet · About LEMON Manuals