LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> ES 350 >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) >> Navigation Receiver >> Removal (07/2015 -) >> Procedure

Removal (07/2015 -): Procedure

  1. PRECAUTION 

    (Refer to PRECAUTION [07/2015 - 08/2016] Refer to PRECAUTION [08/2016 - ] )

    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Refer to PRECAUTION (07/2015 -) ).

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column) 

    Refer to PROCEDURE - Step 1

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION (07/2015 -) ).

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH 

    Refer to PROCEDURE - Step 11

  6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 12

  7. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 13

  8. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET 

    Refer to PROCEDURE - Step 8

  9. REMOVE NO. 1 RADIO BRACKET 
    1. Remove the 4 screws and No. 1 radio bracket.
      GTY498636Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 2 RADIO BRACKET 
    1. Remove the 4 screws and No. 2 radio bracket.
      GTY517744Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE RADIO RECEIVER ASSEMBLY 
scientia non olet · About LEMON Manuals