LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> ES 350 >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio / Video System (Service Information) >> Radio Receiver >> Removal [07/2015 - ] >> Procedure

Removal [07/2015 - ]: Procedure

  1. PRECAUTION (w/ DAB Function) 

    Refer to PRECAUTION [07/2015 - ] .

    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Refer to PRECAUTION [07/2015 - ] ).

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column) 

    Refer to PROCEDURE - Step 1

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ DAB Function) 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [07/2015 - ] ).

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH 

    Refer to PROCEDURE - Step 11

  6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 12

  7. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 13

  8. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET 
    1. Remove the 4 bolts.
      GTY509362Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 2 clips and 2 claws.
      GTY509488Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect each connector and remove the radio receiver assembly with bracket.
  9. REMOVE NO. 1 RADIO BRACKET (w/o DAB Function) 
    1. Remove the 4 screws and No. 1 radio bracket.
      GTY400987Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE NO. 2 RADIO BRACKET (w/o DAB Function) 
    1. Remove the 4 screws and No. 2 radio bracket.
      GTY401080Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE NO. 1 RADIO BRACKET (w/ DAB Function) 

    Refer to PROCEDURE - Step 9

  12. REMOVE NO. 2 RADIO BRACKET (w/ DAB Function) 

    Refer to PROCEDURE - Step 10

  13. REMOVE RADIO RECEIVER ASSEMBLY (w/o DAB Function) 
  14. REMOVE RADIO RECEIVER ASSEMBLY (w/ DAB Function) 
scientia non olet · About LEMON Manuals