DTC P0770-15: Shift Solenoid "E" Circuit Short to Battery or Open [10/2017 - ]: Procedure

1. Disconnect the F56 transmission wire connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (Transmission Wire)

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   6 (SR) - Body ground	20°C (68°F)	11 to 15 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  3

Result: 

OK 

See step  2

1. Disconnect the F102 ECM connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F102-32 (SR) - Body ground	20°C (68°F)	11 to 15 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  COMPONENTS [10/2017 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

1. Remove the shift solenoid valve SR.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Shift Solenoid Valve SR

   Refer to DISASSEMBLY [04/2013 - ]

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   Terminal of shift solenoid valve SR connector - Shift solenoid valve SR body	20°C (68°F)	11 to 15 Ω

3. Connect a positive (+) lead from the battery to the terminal of the shift solenoid valve connector, and a negative (-) lead to the shift solenoid valve body. Check that the valve moves and makes an operating sound.

   OK

   Valve moves and makes an operating sound.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPAIR OR REPLACE TRANSMISSION WIRE. Refer to  COMPONENTS [04/2013 - ] 

Result: 

NG 

REPLACE SHIFT SOLENOID VALVE SR. Refer to  COMPONENTS [04/2013 - ]