Installation [10/2017 - 09/2020]: Procedure

1. Press the front No. 1 stabilizer bracket LH against the frame toward the outside of the vehicle and temporarily tighten the bolt (A).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the bolt (B), fully tighten the bolt (A), and then install the 2 bolts (C).

   Torque: 49 N.m (500 kgf/cm, 36 ft.lbf) 

3. Install the wire harness clamp to the front No. 1 stabilizer bracket LH.

1. Press the front No. 1 stabilizer bracket RH against the frame toward the outside of the vehicle and temporarily tighten the bolt (A).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the bolt (B), fully tighten the bolt (A), and then install the 2 bolts (C).

   Torque: 49 N.m (500 kgf/cm, 36 ft.lbf) 

3. Install the 2 wire harness clamps to the front No. 1 stabilizer bracket RH.

1. Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Cutout
   *b	Bushing Stopper
   	Front of the Vehicle
   	Outside of the Vehicle

   NOTE:

   When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the front of the vehicle.

1. Install the front stabilizer bar to the vehicle so that the identification mark is positioned on the right side of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark
   	Front of the Vehicle
   	RH Side

1. Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bracket LH with the 2 bolts.

   Torque: 49 N.m (500 kgf/cm, 36 ft.lbf) 

HINT: 

Perform the same procedure as for the LH side.

for 2GR-FKS: Refer to PROCEDURE - Step 101

for 8AR-FTS: Refer to PROCEDURE - Step 75

HINT: 

Perform the same procedure as for the LH side.

1. Install the front stabilizer link assembly LH to the front stabilizer bar and front lower suspension arm assembly LH with the 2 nuts.

   Torque: 84 N.m (857 kgf/cm, 62 ft.lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

HINT: 

Perform the same procedure as for the LH side.

for 2GR-FKS: Refer to PROCEDURE - Step 29

for 8AR-FTS: Refer to PROCEDURE - Step 28

Refer to PROCEDURE - Step 1

for 2GR-FKS: Refer to PROCEDURE - Step 103

for 8AR-FTS: Refer to PROCEDURE - Step 78

Torque: 103 N.m (1050 kgf/cm, 76 ft.lbf) 

Refer to ADJUSTMENT [10/2016 - 09/2020]