REMOVAL (To 8/2009): Removal
- PRECAUTION (w/ Navigation System for HDD) NOTE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Air Suspension) NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY . Refer to REMOVAL - Step 11
- REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY . Refer to REMOVAL - Step 12
- REMOVE INSTRUMENT PANEL GARNISH LH . Refer to REMOVAL - Step 22
- REMOVE NO. 1 SWITCH HOLE BASE . Refer to REMOVAL - Step 23
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL - Step 24
- REMOVE INSTRUMENT PANEL FINISH PANEL . Refer to REMOVAL - Step 34
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL . Refer to REMOVAL - Step 35
- REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER . Refer to REMOVAL - Step 10
- REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY
- Disengage the 2 clamps.
- Using a screwdriver, disengage the 2 claws and remove the hazard warning signal switch assembly.